[Smeargle2Member]

You know how it takes so much energy to get the access code visible? I accidentally found a much easier way: Get it a little bit wet with warm water. It doesn't even damage the sticker. Just get a little bit of warm-hot water on your fingertip, and dab the sticker. It should show immediately.

[ben5292001Member]

Cool!!!

[Smeargle2Member]

Oh, yeah. Well I tried it a few times yesterday, and today it's fine. I tried it again a few minutes ago, too. I don't think it''l mess it up unless you do it a lot, or leave it wet for too long.

[omegadragonoidMember]

I have a question related to DNA codes, is the there supposed to be a DNA on Quake Dragonoid?

[bakuempire77Member]

I have a question related to DNA codes, is the there supposed to be a DNA on Quake Dragonoid?

yes it is on the inside on the side with the full cover not the one with the holei use a heater the reveal the code. it comes out perfectedit: oh ya pyrus quake drago has 1000g if u guys didnt know

[Smeargle2Member]

Cool. But if you're nowhere near a heater, water might be a little easier to find… Also, if you're going to just dab it with your finger, I realized that you have to have semi-hot water. Room temperature water won't be enough.

[bakuempire77Member]

heater in car?

[MapingMember]

I use a lamp. Let it heat up for a while, and touch the sticker to the lightbulb.

[Lucario_xMember]

Hoodie pocket.Or rub your hands together untill you think they're about to be burned then rub.

[darkushadesMember]

This actualy works,I tryed everything but the lamp idea

[MapingMember]

This actualy works,I tryed everything but the lamp idea

It's easy, it takes ten seconds to heat up, them two seconds on the bulb, and there it is.

[Author]

Posts