[Primo AltairMember]

I have 2 pyrus/subterra neo dragos, pyrus primary and subterra primary. I have switched every part that can be switched, and it loos very good. However, I need to get out the metal rods holding the horns in place, so they can be switched. The horns are the only thing that haven't been switched yet. I can't get the rods out through any methood. If anyone has a soloution, please post.

[Abce2Member]

Somehow how I did it on my Hylash on accident, I'll try to replicate it.

[KohdokMember]

First, you need a mini-screwdriver that is the same caliber as the offending pin. Most $1 mini screwdriver sets have one you can use.2nd, boil your Bakugan in water, do NOT let it touch the bottom. This softens the plastic and makes the rod easier to move.Last, use the screwdriver to jam out the pin, using something solid like a table to press against. If you're having trouble, it's probably the rough end. All pins have a rough end to hold it in place, so make sure that is the end that comes out first.

[NP2.0Member]

Are you serious about the boiling, it doesn't mess up the bakugan at all?

[KohdokMember]

Are you serious about the boiling, it doesn't mess up the bakugan at all?

Not yet. The plastic can take a lot of heat, more than mere boiling water can cause. The heated pot CAN, however, hence why I say to avoid touching the bottom.If you're that worried, just use really hot tap water.

[Primo AltairMember]

What about the paint?

[1tdawgMember]

Teh paint WILL come off

[Primo AltairMember]

The paint stayed on, and I will be able to post pics of the Dragos soon, if anyone wants to see them.

[KohdokMember]

Teh paint WILL come off

Not in my experience. What were you boiling? Ammonia?

[1tdawgMember]

Yezz, use daht amonis to getz high! >:D

[BakuexpertMember]

Let me put my bakugan in an amonnia solution…*Puts*OMFG! It melts! Plastic ball becomes plastic jam....

[Author]

Posts